To Power A Terminal And Charge Its Main Battery; Removing The Cable - Honeywell Dolphin 70e Black User Manual

To Power a Terminal and Charge its Main Battery

Ensure all components are dry prior to mating terminals/batteries with peripheral devices. Mating wet
components may cause damage not covered by the warranty.
We recommend use of Honeywell Li-Ion battery packs. Use of any non-Honeywell battery may result in
damage not covered by the warranty.
1. Install the main battery in the terminal; see
2. Mount the Mobile base and install the power cable; see
3. Pull the spring latch back and insert the Dolphin 70e Black into the terminal well. Charging begins
immediately if required by the Dolphin terminal.
Note: Align the contacts on the back panel of the terminal with the charging contacts on the Mobile Base.

Removing the Cable

Attempting to remove the cable without disengaging the lock
may result in damage to the base and power cable not covered
by the warranty.
1. Twist the cable 90° counterclockwise to disengage the
cable lock.
2. Remove the cable from the power jack.
Install the Battery on page
Mounting the Mobile Base
2-1.
on page
1
2
11-3.
11 - 5