Power; Connecting Power To The Chargebase; Charging The Main Battery; To Power A Terminal And Charge Its Main Battery - Honeywell Dolphin 70e Black User Manual

Power

The terminal requires 12 Volts DC input for battery charging and power output to the terminal. The power
adapter included with the base, converts the voltage from the AC power source to 12 volts DC. Use only
a UL Listed power supply, which has been qualified by Honeywell with output rated at 12VDC and
5 amps with the device. The operating temperature range is -10° to 50°C (14° to 122°F).
Honeywell recommends that you leave the ChargeBase connected to its power source at all times, so
that it is always ready to use.
We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-Honeywell
peripherals, cables, or power adapters may cause damage not covered by the warranty.

Connecting Power to the ChargeBase

A/C Power Cord
1. Plug the A/C power cord into the power adapter.
2. Plug the power cable into the power connector on the back of the ChargeBase.
3. Plug the A/C power cord into a grounded power source.
4. The base is ready to begin charging terminals.

Charging the Main Battery

The base provides power to the Dolphin terminals and allows charging of the batteries in the terminals.
The battery of each terminal charges in 4 hours for the standard battery or 6 hours for the extended
battery. The intelligent battery charging system incorporated into all Dolphin terminals prevents
overcharging, which means that Dolphin terminals may be seated in the base indefinitely without
damage to the terminals, batteries, or the base.
For more information about Honeywell battery packs and how to check battery power level in your
terminal, refer to Battery

To Power a Terminal and Charge its Main Battery

Ensure all components are dry prior to mating terminals/batteries with peripheral devices. Mating wet
components may cause damage not covered by the warranty.
1. Install the battery in the terminal, see
12 - 4
Power LED
(page 3-10).
Install the Battery
Power Adapter
on page 2-1.
Power Connector Cable