Zanussi ZWS 3101 User Manual page 20

Positioning and levelling
• Install the appliance on a flat hard floor.
• Make sure that carpets do not stop the air
circulation below the appliance.
• Make sure that the appliance does not
touch the wall or other units
• Loosen or tighten the feet to adjust the lev-
el. A correct adjustment of the appliance
level prevents the vibration, noise and the
movement of the appliance when in opera-
tion.
• The appliance must be level and stable.
Caution! Do not put cardboard, wood or
equivalent materials below the appliance
feet to adjust the level.
20
The inlet hose
• Connect the hose to the appliance. Loose
x4
the ring nut to set it in the correct position.
x4
Caution! Make sure that there are no
leaks from the couplings.
Do not use an extension hose if the inlet
hose is too short. Contact the service cen-
tre for the replacement of the inlet hose.
Water drainage
There are different procedures to connect the
drain hose:
With the plastic hose guide
• Connect the water
inlet hose to the
cold water tap with
3/4 thread.
www.zanussi.com