Care And Cleaning - Zanussi ZWS 3101 User Manual

2. Turn the programme knob again to activate
the appliance. Now, you can set a new
washing programme.
The appliance does not drain the water.
Change a function
You can change only the delay and spin func-
tion before they operate.
Press the related button to set the new value.
Set the delay start
1. Press the delay start button again and
again until the display shows the number
hours.
2. Press the start button, the appliance starts
the countdown of the delay start. The sym-
bol h flashes in the display and the start
button indicator is off.
When the countdown is completed, the
programme starts automatically and the
start button indicator comes on.
You can cancel or change the set of the
delay start also when the appliance starts
the countdown.
Cancel the delay start
Press the delay start button again and again
until the display shows 0.
The programme starts and the start button indi-
cator comes on.
Open the door
While a programme operates, the appliance
door is locked.
To open the appliance door:
1. Turn the programme knob to
vate the appliance.
2. Wait for some minutes before to open the
appliance door.
3. Close the appliance door.

Care and cleaning

Warning!
Disconnect the appliance from the mains sup-
ply before you clean it.
12
4. Set the programme again.
If the temperature and level of the water in
the drum are too high, you cannot open
the door.
To open the appliance door:
• Do the steps 1 and 2 again.
• Wait for some minutes.
• Make sure that no water is in the drum.
At the end of the programme
• The appliance stops automatically.
• The display shows the End symbols.
• Turn the programme knob to
vate the appliance.
• Remove the laundry from the appliance.
Make sure that the drum is empty.
• Keep the door ajar, to prevent mildew and
odours.
• Close the water tap.
The washing programme is completed,
but there is water in the drum:
– The Rinse Hold function or a programme that
stops with water in the drum is set.
– The door stays locked and the start button
indicator flashes.
– You must drain the water before to open the
door.
To drain the water:
1. If necessary, decrease the spin speed.
2. Press the start button. The appliance drain
the water and spin.
3. When the programme is completed:
to deacti-
– The display shows the End symbols.
– You can open the door.
4. Turn the programme knob to
vate the appliance.
External cleaning
Clean the appliance only with soap and warm
water. Fully dry all the surfaces.
Caution! Do not use alcohol, solvents or
chemical products.
to deacti-
to deacti-
www.zanussi.com