Zanussi ZWS 3101 User Manual page 16

Problem
The appliance does not
fill with water.
The appliance does not
drain the water.
The spin phase does not
operate.
There is water on the
floor.
You cannot open the ap-
pliance door.
The appliance makes an
unusual noise.
16
Possible cause
The programme knob is not in the
correct position.
The delay start is set.
It is available only for models with
the Delay start.
The water tap is closed.
The water inlet hose is damaged.
The filter in the water inlet hose is
blocked .
The water tap is blocked or there
is limescale on it.
The connection of the water inlet
hose is not correct.
The water pressure is too low.
The water drain hose is dam-
aged.
The filter of the drain pump is
blocked.
The connection of the water drain
hose is not correct.
A washing programme without
the drain phase is set.
The function Rinse Hold is on.
The spin phase is off.
The filter of the drain pump is
blocked.
Balance problems with the laun-
dry load.
Leakages from the couplings of
the water hoses.
Leakages from the drain pump.
The water drain hose is dam-
aged.
The washing programme is in op-
eration.
There is water in the drum.
Incorrect level of the appliance.
You did not remove the packag-
ing and/or the transit bolts.
Possible solution
Turn the programme knob in the correct po-
sition.
To start immediately the programme, cancel
the delay start.
Open the water tap.
Make sure that the water inlet hose has no
damages.
Clean the filter. Refer to 'Care and cleaning'.
Clean the water tap.
Make sure that the connection is correct.
Contact your local water authority.
Make sure that the water drain hose has no
damages.
Clean the filter of the drain pump. Refer to
'Care and cleaning'.
Make sure that the connection is correct.
Set the drain programme.
Set the drain programme.
Set the spin programme.
Clean the filter of the drain pump. Refer to
'Care and cleaning'.
Adjust manually the items in the tub and
start the spin phase again.
Make sure that the couplings are tight.
Make sure that the drain pump filter is tight.
Make sure that the water inlet hose has no
damages.
Let the washing programme end.
Set the drain or the spin programme.
Adjust the level of the appliance. Refer to
'Installation'.
Remove the packaging and/or the transit
bolts. Refer to 'Installation'.
www.zanussi.com