Zanussi ZWS 3101 User Manual page 14

4. When the container is full of water,
screw the filter again and empty the con-
tainer. Do steps 3 and 4 again and again
until no more water flows out from the
drain pump.
1
2
14
1. Open the pump
door.
2. Put a container
below the recess
of the drain
pump to collect
the water that
flows out.
3. Unscrew the fil-
ter to let the wa-
ter flow out.
5. Unscrew the fil-
ter and remove it.
6. Remove fluff and
objects from the
pump.
2
1
9. Close the drain pump door.
Clean the inlet valve filter
It could be necessary to clean the filter when:
• The appliance does not fill with water.
• The appliance fills with the water for a long
time.
Warning! Disconnect the mains plug from
the mains socket.
To clean the filter:
• Close the water tap.
• Remove the inlet hose behind the appli-
ance.
• Clean the filter in the valve with a stiff
brush or a towel.
7. Make sure that
the impeller of
the pump can
turn. If this does
not occur, con-
tact the service
centre.
8. Clean the filter
under the water
tap and put it
back in the
pump.
Caution! Make
sure that you
tighten correctly the
filter to prevent leak-
ages.
www.zanussi.com