Hooking Up The Turntable - Sony PS-LX300USB Operating Instructions Manual

To remove the dust (over
With the dust cover fully opened, grasp both
sides of the cover, then remove it carefully.
Hinge pocket
, - Hinge ----,
~ ~
Tip
You can use the turntable leaving the dust cover removed.
In that case, store the cover correctly.
To install the dust (over
Insert the hinge pockets on the dust cover into
the hinges on the rear of the cabinet.
Hooking Up the Turntable
The phono cables come attached to the rear of
the cabinet.
1
Set the PHONO/L1NE switch (on
the rear of the turntable) according
to the jacks of your stereo system
(amplifier).
PHONO LINE
• When your stereo system (amplifier) has
PHONO input jacks (connect to PHONO
input jacks)
--+set to PHONO. The Equalizer function
is off.
• When your stereo system (amplifier) does
not have PHONO input jacks (connect to
AUX, VIDEO input jacks, etc.)
--+set to LINE. The Equalizer function
is on.
2
Connect the cable with the white
plug to the white (L) jack and connect
the cable with the red plug to the red
(R) jack.
Make sure to insert the plugs firmly into the
jacks. If the plugs are not inserted firmly,
noise may occur.
PHONGIN
3
Connect the AC power cord.
Connect the AC power cord to an AC
wall outlet after completing all of the
connections by performing steps 1 and 2.
~
to awall outlet