Top Cover - GE Profile PTWN8055MMS Technical Service Manual

Top Cover

To remove the top cover:
1. Remove the 4 Phillips-head screws (2 on each
side) that hold the back cover in place. Remove
the back cover.
2. Remove the wire twist tie, hose clamp, and
pressure sensor hose from the outer tub.
3. Remove the 2 plastic wire ties that attach the
top cover wiring harness to the inside corner of
the washer cavity.
Plastic Wire
Tie (1 of 2)
Pressure Sensor Hose
4. Roll up the plastic cover that protects the top
Note: When installing the top cover, make sure to
roll down the plastic cover that protects the main
wire harness connectors.
5. Disconnect the 7 top cover wiring harness
Wire Twist Tie
Hose Clamp
– 22 –
cover wire harness connectors.
Plastic Cover
connectors.
Disconnect
Disconnect
(Continued Next Page)