Outer Tub And Suspension Assembly - GE Profile PTWN8055MMS Technical Service Manual

3. Disconnect the red wire (white connector) from
the high limit.
4. Remove the 4 Phillips-head screws that attach
the thermostat to the outer tub.
Note: Observe the 2 small posts on the bottom
of the tub and 2 cut outs in the thermostat body.
When installing the high limit thermostat, align the
cut outs with the posts for proper orientation. The
reason for proper orientation of the thermostat
is because the heater support is part of the
thermostat body and must be positioned correctly
for the heater to be installed.
Post
View inside heater opening in tub
Heater Support
5. Pull the high limit thermostat from the outer tub.
Caution: To prevent water leakage, make sure the
O-ring is in place before installing the thermostat.
O-ring

Outer Tub and Suspension Assembly

The wash basket, outer tub, and motor are
suspended by 4 rod and spring assemblies. The rod
and spring assemblies are attached to each corner
of the washer cabinet. They extend down and
connect to the bottom of the outer tub.
Post
To remove the outer tub:
WARNING: The outer tub assembly is heavy and
requires 2 people to remove it from the washer
Disconnect
housing. Care should be taken when removing and
installing the outer tub assembly.
1. Remove the top cover. (See
Note: In the following step, water will remain in the
hose even when the tub appears empty. Use care to
avoid water spills.
2. Remove the drain hose from the drain pump.
Note: The drain hose is diffi cult to remove due to a
sealing compound used at the factory.
Thermostat Body
Drain Hose
– 33 –
Suspension Rod
Suspension Rod
a. Squeeze the clamp and slide it back.
b. Carefully break the hose loose by inserting a
small fl at blade screwdriver under the hose
to break the seal.
c. Remove the hose.
.)
Top Cover
Clamp
(Continued Next Page)