GE Profile PTWN8055MMS Technical Service Manual page 23

Note: The front of the washer top is held to the
cabinet with 2 release clips. The back of the washer
top has 2 brackets, each inserted into a hinge
plate attached to the cabinet. When the clips are
released, the washer top cover, when raised, can
pivot on 2 hinge plates.
Bracket (1 of 2)
6. Insert a putty knife between the cabinet and top
cover 7 inches from each side.
7. Open the lid, reach inside, and pull up on the top
cover as you push each release clip.
8. Lift the front of the top cover approximately 12
inches, and then pull the top cover forward to
clear each hinge plate.
9. Continue to lift the top cover until wiring is clear
of the cabinet.
Hinge Plate (1 of 2)
– 23 –
Service Position
The top cover can be placed in a service position to
access the wash basket, suspension rods, and lid
lock.
To place the top cover in the service position:
1. Position the back of the washer 1 foot away
from the wall
2. Insert a putty knife between the cabinet and top
cover 7 inches from either side. (See
3. Open the lid, reach inside, and pull up on the top
cover as you push each release clip.
4. Place a protective cover between the top cover
and the wall.
5. Lift the top cover and carefully place it against
the wall.
Protective Cover
.)
Top Cover