Grandstream Networks GXP2130 Administration Manual page 37

Ring Timeout
Send Anonymous
Anonymous Call
Rejection
Auto Answer
Allow Auto Answer by
Call-Info
Custom Call-Info for Auto
Answer
Refer-To Use Target
Contact
Transfer on Conference
Hangup
No Key Entry Timeout (s)
Use # as Dial Key
GXP2130/GXP2140/GXP2160
FIRMWARE VERSION 1.0.4.10
select the custom ring tone mapped to it. The custom ring tone will be
used if the phone receives SIP INVITE with Alert-Info header in the
following format:
Alert-Info: <http://127.0.0.1>; info=priority
Selects the distinctive ring tone for the matching rule. When the incoming
caller ID or Alert Info matches the rule, the phone will ring with the selected
ring.
Defines the timeout (in seconds) for the rings on no answer. The default setting
is 60 seconds.
If set to "Yes", the "From" header in outgoing INVITE messages will be set to
anonymous, essentially blocking the Caller ID to be displayed.
If set to "Yes", anonymous calls will be rejected. The default setting is "No".
If set to "Yes", the phone will automatically turn on the speaker phone to
answer incoming calls.
If set to "Yes", the phone will automatically turn on the speaker phone to
answer incoming calls, based on the SIP info header sent from the
server/proxy. The default setting is "No".
Used in addition to match the contents of the info parameter in the Call-Info
header for auto answer.
For example, by default, the call-info header is,
Call-Info: <sip:server_IP>;answer-after=0
The custom part in call-info header is the text "x" as of in "answer-after=x".
If using "Alert-Info" instead, the custom part in alert-info header is the text "x" in
"info=x". By default, the alert-info header is,
Alert-Info: <sip:96.31.248.60>;info=alert-autoanswer;delay=0
If set to "Yes", the "Refer-To" header uses the transferred target's Contact
header information for attended transfer. The default setting is "No".
Defines whether or not the call is transferred to the other party if the initiator of
the conference hangs up. The default setting is "No".
Defines the timeout (in seconds) for no key entry. If no key is pressed after the
timeout, the digits will be sent out. The default value is 4 seconds.
Allows users to configure the "#" key as the "Send" key. If set to "Yes", the "#"
key will immediately dial out the input digits. In this case, this key is essentially
equivalent to the "Send" key. If set to "No", the "#" key is included as part of the
GXP2130/GXP2140/GXP2160
ADMINISTRATION GUIDE
Page 37 of 68