Table of Contents
Advertisement
MBR1200B| USER MANUAL Firmware ver. 4.1.1
CRADLEPOINT
7.1.3
General Settings
• Enabled: Select/deselect to enable/disable.
• Force NAT: Normally the LAN Route Mode
controls the use of NAT (network address
translation). When this option is selected the
router will always perform NAT when traffic is
sent out from this device.
• Priority: This number controls failover and
failback order. The lower the number, the higher
the priority and the more use the device will get.
This number will change when you move devices
around with the priority arrows in the WAN
Interfaces list.
• Load Balance: Select to allow this device to be
available for the Load Balance pool.
• Download bandwidth: Defines the bandwidth for
use in Load Balance algorithms. (Range: 128
Kb/s to 1 Gb/s.)
• MTU: Maximum transmission unit. This is the size
of the largest protocol data unit that the device
can pass. (Range: 46 to 1500 Bytes.)
• Hostname (This only shows for certain WAN devices.)
© 2013 CRADLEPOINT, INC.
PLEASE VISIT
HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/
FOR MORE HELP AND RESOURCES
PAGE 91
Advertisement
Table of Contents
