Cradlepoint MBRB Product Manual page 117

MBR1200B| USER MANUAL Firmware ver. 4.1.1
CRADLEPOINT
uploaded to the router. Enable Certificate Support in the Global VPN Settings to upload a single set of certificates for the
router to use.
Pre-shared Key: Create a password or key. The routers on both sides of the tunnel must use this same key.
Mode: Tunnel or Transport. Tunnel Mode is used for protecting traffic between different networks, when traffic must
pass through an intermediate, untrusted network. Transport Mode is used for end-to-end communications (for example,
for communications between a client and a server).
Initiation Mode: "Always On" or "On Demand." "Always On" is used if you want the tunnel to initiate the tunnel
connection whenever the WAN becomes available. Select On Demand if you want the tunnel to initiate a connection if
and only if there is data traffic bound for the remote side of the tunnel.
Tunnel Enabled: Enabled or Disabled.
MBR1200 Quick Connect: VPN tunnels in the MBR1200B have more choices than they did in the MBR1200, so it is
more complex to configure. Check this box to simplify setup by streamlining your options.
WAN Binding: WAN Binding is an advanced optional parameter used to configure a VPN tunnel to ONLY operate when
the specified WAN device(s) are available and connected. An example use case is a router with both a primary and
backup WAN connection and the VPN tunnel should only be used when the system has failed over to the backup
connection. This use case makes the most sense when the primary and backup connections are mutually exclusive, i.e.
not connected at the same time.
Select each of the following to create a condition for your WAN Binding setup. When:
• Port (Blue Ethernet; Yellow Ethernet 1, 2, 3, 4; USB 1, 2; ExpressPort):
• Manufacturer:
• Model: Set your rule according to the specific model of modem.
• Type (Ethernet, LTE, Modem, WiMAX, Wireless as WAN, HSPA, Ethernet):
• Serial Number:
• MAC Address:
• Unique ID: Select by ID. This is generated by the router and displayed when the device is connected to the router.
Condition: Select "is," "is not," "starts with," "contains," or "ends with" to create your condition's statement.
Value: If the correct values are available, select from the dropdown list. You may need to manually input the value.
© 2013 CRADLEPOINT, INC.
Select by the manufacturer, such as Sierra Wireless.
Select 3G or LTE modem by Serial Number.
Select WiMAX modem by MAC Address.
PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/
Select by port.
Select by type of Internet source.
FOR MORE HELP AND RESOURCES PAGE 115