Cradlepoint MBRB Product Manual page 116

MBR1200B| USER MANUAL Firmware ver. 4.1.1
CRADLEPOINT
7.5.1 Page 1: General
Tunnel Name: Give the tunnel a name that uniquely identifies it.
Anonymous Mode: Select to
any IP address.
Responder Mode: When enabled, the router will not initiate
negotiation with peers. Otherwise it will start negotiations as
soon as possible.
Local Identity: Specifies the identifier sent to the remote host
during phase 1 negotiation. If left blank it will default to the IP
address of the WAN connection. Currently we only support
identifiers in the form of an IP address, a user-fully qualified
domain name (user@mydomain.com) or just a fully qualified
domain name (www.mydomain.com). If the remote side of the
tunnel is configured to expect an identifier, then both must
match in order for the negotiation to succeed. If NAT-T is being
used, a single word (instead of an address) can be used if a
DynDNS connection is not being used.
Remote Identity: Specifies the identifier we expect to receive
from the remote host during phase 1 negotiation. If no identifier
is defined then no verification of the remote peer's identification
will be done. Currently we only support identifiers in the form of
an IP address, a user-fully qualified domain name
(user@mydomain.com) or just a fully qualified domain name
(www.mydomain.com). If left blank we will default to the IP
address of the WAN connection. If NAT-T is being used, a single word (instead of an address) can be used if a DynDNS
connection is not being used.
Authentication Mode: Select from Pre-Shared Key and Certificate. Pre-Shared Key is used when there is a single key
common to both ends of the VPN. Certificate requires the creation of a set of certificates and a private key that can be
© 2013 CRADLEPOINT, INC.
allow remote connections from
PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 114