Vcr Video And Audio To An Antenna Or Wall Outlet Cable - Mitsubishi Electric WD-52525 Owner's Manual

Connecting VCR Video and Audio to an Antenna or Wall Outlet
Cable
VCR Video and Audio to an Antenna or
Wall Outlet Cable
Figure 5
A two-way RF splitter, 3 coaxial cables, right and left audio
cables and a S-Video or Video cables are required. These are
not included with the TV.
1. Connect the incoming cable or Antenna to IN on the
RF splitter.
2. Connect one coaxial cable from OUT on the RF
splitter to ANTENNA IN on the VCR back panel.
3. Connect one coaxial cable from OUT on the RF
splitter to ANT-1 MAIN on the TV back panel.
4. To use the TV speakers with the VCR, connect a
set of audio cables from AUDIO OUT on the VCR
back panel to INPUT-1 AUDIO-LEFT (MONO) and
AUDIO-RIGHT on the TV back panel. The red cable
connects to the R (right) channel and the white
cable connects to the L (left) channel. If your VCR
is mono (non-stereo), connect only the white (left)
cable.
TV back panel section
3.
1.
Incoming
2.
Cable
3.
Figure 5. Connecting a VCR to an Antenna or Wall Outlet Cable
20
6. 7.
IEEE1394
INPUT/OUTPUT
PC
IR EMITTER
VGA/SVGA/XGA/
NetCommand R
720p
AUDIO AUDIO
60 Hz MONITOR MONITOR
VIDEO VIDEO S-VIDEO S-VIDEO
R L(MONO) OUTPUT OUTPUT
R L(MONO)
L
L DVI
Analog Audio AUDIO 2
R R
ANT-2
PC-
AUX AUDIO/VIDEO 1 AUDIO/VIDEO 1
AUDIO
DTV/ DTV/
CABLE/ CABLE/
VHF/ INPUT-1 INPUT-1
VHF/
UHF UHF
ANT-2 ANT-1 INPUT-2
HDMI PC-
M-LINK MAIN AUX
INPUT
M-LINK
CONTROL/
RS-232C
DIGITAL
AUDIO
5.
4.
Attach only one cable type
5. Connect either an S-Video or Video cable from
VIDEO OUT on the VCR back panel to INPUT-1
VIDEO on the TV back panel. Only one type of
video cable should be connected. S-Video is
recommended, if available.
6. For NetCommand® controlled recordings, connect
a set of audio cables from AUDIO IN on the VCR
back panel to MONITOR OUTPUT AUDIO/VIDEO 1
AUDIO-LEFT (MONO) and AUDIO-RIGHT on the TV
back panel. The red cable connects to the R (right)
channel and the white cable connects to the L (left)
channel.
7. Complete the NetCommand controlled recordings
connections by connecting a Video cable from
VIDEO IN on the VCR back panel to MONITOR
OUTPUT AUDIO/VIDEO 1 on the TV back panel.
6.
VCR back panel
�� �����
If your VCR has a video channel
4.
or RF ON/OFF switch, set it to OFF.
5.
7.
5.
S-Video
recommended
if available
Note:
NetCommand®
will assume your
VCR is connected
to inputs as
shown on this
2. page. If you use
any other inputs
for your VCR or
add a second
VCR, this change
must match in
the NetCommand
system. See Edit
NetCommand... in
Chapter 3 for more
information.