Vcr To An Antenna Or Wall Outlet Cable (Audio & Video) - Mitsubishi Electric WD-52628 Owner's Manual

Connecting a VCR to an Antenna or Wall Outlet Cable
Connecting VCR Audio and Video to the TV
VCR to an Antenna or Wall Outlet
Cable (Audio & Video)
Figure 5
A two-way RF splitter, 3 coaxial cables, right and left audio
cables, and an S-video or video cable are required. These are
not included with the TV but are available at most electronics
stores.
1. Connect the incoming cable or Antenna to IN on the
RF splitter.
2. Connect one coaxial cable from OUT on the RF
splitter to ANTENNA IN on the VCR back panel.
3. Connect one coaxial cable from OUT on the RF
splitter to ANT-1 MAIN on the TV back panel. This
connection also allows you to use the TV Guide On
Screen® feature.
4. To use the TV speakers with the VCR, connect a set
of audio cables from AUDIO OUT on the VCR back
panel to INPUT-1 AUDIO-LEFT (MONO) and AUDIO-
RIGHT on the TV back panel. The red cable connects
to the R (right) channel and the white cable connects
to the L (left) channel. If your VCR is mono (non-
stereo), connect only the white (left) cable.
Figure 5. Connecting a VCR to an Antenna or Wall Outlet Cable
26
Chapter 2. Connecting
5. Connect either an S-Video or Video cable from
VIDEO OUT on the VCR back panel to INPUT-1
VIDEO on the TV back panel. Only one type of
video cable should be connected. S-Video is
recommended, if available.
6. For NetCommand®-controlled recordings (including
TV Guide On Screen), connect a set of audio cables
from AUDIO IN on the VCR back panel to RECORD
OUTPUT/AUDIO-LEFT and AUDIO-RIGHT on the TV
back panel. The red cable connects to the R (right)
channel and the white cable connects to the L (left)
channel.
7. Complete the NetCommand controlled recordings
connections by connecting a Video cable from
VIDEO IN on the VCR back panel to RECORD
OUTPUT/VIDEO on the TV back panel.
COMPONENT
INPUT YPbPr (480i/480p/720p/1080i)
1 2
1 2
INPUT
Y
DVI
Analog Audio
S-VIDEO
Pb
1 2
VIDEO Pr
AUDIO-
AUDIO-
LEFT/
LEFT/
(MONO)
(MONO)
AUDIO-
AUDIO-
RIGHT
RIGHT
MONITORLINK™/HDMI
VIDEO 480i/480p/720p/1080i
AUDIO PCM LINEAR
1
2
IR EMITTER
Net Command
DTV/CABLE/
VHF/UHF
DIGITAL
AUDIO
CableCARD™ ANT 1 CARD TOP
ANT 1 / MAIN ANT 2 / AUX OUTPUT USE WITH
Note:
NetCommand®
will assume your
VCR is connected
to inputs as shown
on this page. If
you use any other
inputs for your VCR
or add a second
VCR, this change
must match in
the NetCommand
system. See Edit
NetCommand... in
Chapter 3 for more
OUTPUT
AUDIO RECORD information.
OUTPUT OUTPUT
VIDEO
AUDIO-
LEFT/
(MONO)
AUDIO-
RIGHT
PC - 60Hz
VGA, W-VGA,
SVGA, W-SVGA,
XGA, 1280 X 720
IEEE 1394
INPUT/
OUTPUT