Vcr Video And Audio To An Antenna Or Wall Outlet Cable - Mitsubishi Electric WS-48515 Owner's Manual

Connecting VCR Video and Audio to an Antenna or Wall Outlet
Cable
VCR to Antenna or Wall Outlet Cable
Figure 5
A two-way RF splitter, 3 coaxial cables, right and left audio
cables and S-Video or Video cables are required. These are not
included with the TV.
1. Connect the incoming cable or Antenna to IN on the
RF splitter.
2. Connect one coaxial cable from OUT on the RF
splitter to ANTENNA IN on the VCR back panel.
3. Connect one coaxial cable from OUT on the RF
splitter to ANT-1 MAIN on the TV back panel.
4. To use the TV speakers with the VCR, connect a
set of audio cables from AUDIO OUT on the VCR
back panel to INPUT 1 AUDIO-LEFT (MONO) and
AUDIO-RIGHT on the TV back panel. The red cable
connects to the R (right) channel and the white
cable connects to the L (left) channel. If your VCR
is mono (non-stereo), connect only the white (left)
cable.
2.
Incoming Cable
1.
3.
ANT-2
SERVICE IEEE1394
PORT INPUT/OUTPUT
– –
Figure 5. Connecting a VCR to an Antenna or Wall Outlet Cable
Note:NetCommand® will assume your VCR is
connected to inputs as shown here. If you use any
other inputs for your VCR or add a second VCR, this
change must match in the NetCommand system.
See Edit NetCommand... pages 35-42 for more
information.
Attach
only
one
cable
S-Video INPUT
INPUT MONITOR OUTPUT MONITOR OUTPUT
type
1 2
recommended 1 2 AUDIO/VIDEO 1
if available
5.
White
4.
Red
COMPONENT
YPbPr (480i/480p/1080i)
1
TUBE
R
3.
DVI
Analog Audio
Digital Video
Digital Audio
ANT-1 ANT-1
MAIN MAIN
AUX
DIGITAL
AUDIO
CableCARD TM SLOT
(DTV/CABLE /VHF/UHF) (DTV/CABLE /VHF/UHF) – –
5. Connect either an S-Video or Video cable from
VIDEO OUT on the VCR back panel to INPUT 1
VIDEO on the TV back panel. Only one type of
video cable should be connected. S-Video is
recommended, if available.
6. For NetCommand® controlled recordings, connect
a Video cable from VIDEO IN on the VCR back panel
to MONITOR OUTPUT AUDIO/VIDEO 1 on the TV
back panel.
7. Complete the NetCommand controlled recording
connection by connecting a set of audio cables
from AUDIO IN on the VCR back panel to MONITOR
OUTPUT AUDIO/VIDEO 1 AUDIO-LEFT (MONO) and
AUDIO-RIGHT on the TV back panel. The red cable
connects to the R (right) channel and the white cable
connects to the L (left) channel.
TV back panel
AUDIO 2
S-VIDEO S-VIDEO
6.
VIDEO
VIDEO
AUDIO- AUDIO-
White
LEFT/
LEFT/
(MONO)
(MONO)
AUDIO- AUDIO-
Red
RIGHT RIGHT
7.
2
Y
Pb
Pr
If your VCR has a video channel
AUDIO- or RF ON/OFF switch, set it to OFF.
LEFT/
(MONO)
AUDIO-
RIGHT
Additional connection cables are
not provided with the TV. They are
available at most electronic stores.
VCR back panel
4.
Red
HS-U748
White
5.
5.
Attach
only
one
cable
S-Video type
recommended
if available
IMPORTANT
2.
6. 7.
W R
h
e
i d
t
e
17