Configure Wep In Bridge Mode - D-Link DAP-1522 Xtreme N Duo User Manual

Section 4 - Security
It is recommended to enable encryption on your wireless access point before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to the
added overhead.
1. Log into the web-based configuration by opening a web browser and entering the IP address of the bridge (19.168.0.50).
Click on Setup and then click Wireless Settings on the left side.
. Next to Security Mode in the Wireless Security Mode section,
select WEP.
3. Next to WEP Key Length in the WEP section, select both the type
of input (hexidecimal or ASCII) and the level of encryption (64-
bit or 18-bit). Hex - (recommended) Letters A-F and numbers 0-9
are valid. .
4. Next to Default WEP Key and the first selection on the drop-down menu, Next to Default WEP Key and the first selection on the drop-down menu, WEP Key 1. Enter a WEP key that you create in the
WEP Key value and Verify WEP Key value fields. Make sure you enter this key exactly on all your wireless devices. You may
enter up to 4 different keys using the Default WEP Key drop-down menu. .
5. Next to Authentication, select Open or Shared Key.
6. Click Save Settings at the top of the window to save your settings. If you are configuring the access point with a wireless
adapter, you will lose connectivity until you enable WEP on your adapter and enter the same WEP key as you did on the
access point.
D-Link DAP-15 User Manual

Configure WEP in Bridge Mode

select both the type
68