Section 3 - Configuration
Save To Local Hard
Use this option to save the current access point
Drive:
configuration settings to a file on the hard disk of the
computer you are using. First, click the Save button.
You will then see a file dialog, where you can select a
location and file name for the settings.
Load From Local
Use this option to load previously saved access point
configuration settings. First, use the Browse control
Hard Drive:
to find a previously save file of configuration settings.
Then, click the Load button to transfer those settings
to the access point.
This option will restore all configuration settings back
Restore To Factory
Default:
to the settings that were in effect at the time the access
point was shipped from the factory. Any settings that
have not been saved will be lost, including any rules
that you have created. If you want to save the current
access point configuration settings, use the Save
button above.
Reboot The Device:
Click to reboot the bridge.
D-Link DAP-15 User Manual
System
58