AMT Datasouth Accel-7350 Service Manual page 66

(3) Home Sensor Assembly Replacement
Home Sensor Assembly is located on the left side of the FFC bottom plate assembly.
REMOVAL
Step 1. Remove the top enclosure.
Step 2. Remove 2 pan head screws (S-17) from the mechanism stoppers left and right corners
of the mechanism. Rotate the mechanism up.
Step 3. Disconnect the home sensor harnesses on the control PCB.
Step 4. Remove the cassette holder L, 2 pan head screws (S-6).
Step 5. Detach the home sensor assembly by removing 2 pan head tapping screws (S-12).
(4) Paper Sensor Assembly Replacement
The Paper Sensor Assembly is located beneath the plastic molded metric scale (front printer view).
REMOVAL
Step 1. Remove the top enclosure.
Step 2. Remove 2 pan head screws (S-17) from the mechanism stoppers left and right corners
of the mechanism. Rotate the mechanism up.
Step 3. Disconnect the harness of the paper sensor assembly on the control PCB.
Step 4. Remove the metric scale, 4 pan head tapping screws (S-12).
Step 5. Detach the Paper sensor assembly by removing 1 screw (S-13).
INSTALLATION
Follow the reverse of the above procedure.
65