AMT Datasouth Accel-7350 Service Manual page 51

(3) Mechanical Block Replacement
REMOVAL
Step 1.The paper rack and cover L/R must be removed.
Step 2. The top enclosure must be removed.
Step 3. Remove 1-pan head screws (M4 x 32.6) on the right front mechanism holder B, rotate
the metal plate to the right. Remove 1-pan head screw (M4 x 32.6), 1-pan head screw
(S-18) on the left mechanism holder B. Remove the mechanism holders and the switch
holder.
Step 4. Remove 2 pan head screws (S-17) from the mechanism stoppers (left and right rear
corners of the mechanism).
Step 5. Lift up the back of the mechanism, and disconnect all the harnesses from the printed
circuit board assembly. Remove the mechanism from the bottom enclosure.
INSTALLATION
Follow the reverse of the above procedure.
(4) Bottom enclosure Replacement
REMOVAL
Step 1. The top enclosure and the mechanism must already be removed.
Step 2. Remove 2 flat head screws (S-21) on the power jack. Remove GND screws (S-14) (Note:
do not separate the screw from its GND wire.)
Step 3. Disconnect all the harnesses from the printed circuit board assembly.
INSTALLATION
Follow the reverse of the above procedure.
Right Side View
50