Paper Edge Sensor Replacement - AMT Datasouth Accel-7350 Service Manual

Paper edge sensor replacement

REMOVAL
Step1: Turn off the printer power switch, and then open the printer cover, move the print head
to the left of the printer.
Step2: Remove ribbon cassette.
Step4: Remove the carrier cover.
Step5: Remove the paper edge sensor cover.
Step6: Remove the paper edge sensor(s).
Step7: Disconnect the paper edge sensor connector from the carrier housing.
Step8: Install new sensor(s) into the ribbon guide assembly, and tighten the screw.
Step9: Install the paper edge sensor cover(s), route the sensor cable into the cover opening
and tighten the screw.
Step10: Connect the sensor cable(s) plug into the socket on the carrier housing.
Step11: Replace the carrier cover.
Carrier
Cover
Carrier Housing
Paper Edge Cover & Sensors
60