Usb Transfer Speed Change In The Pictbridge Mode (Function Code 45) - Brother HL-4040CN Service Manual

1.4.11 USB Transfer Speed Change in the PictBridge Mode (Function code 45)

<Function>
This function allows you to change the USB transfer speed in the PictBridge mode. If the digital
camera which a user uses cannot be connected in the PictBridge mode, this function may
make it possible.
- PB.Speed=AUTO: Adapts the speed to the capability of the USB device. (Full Speed or High
- PB.Speed=FULL: Fixes the speed to Full Speed. The capability of the USB device is not
(An asterisk "*" appears beside the current setting.)
<Operating Procedure>
(1) Press the
the maintenance mode. Then, press the OK button.
"PB.USBspeed" will appear on the LCD.
(2) Press the OK button. Then, select the required function by pressing the
and press the OK button.
(3) The machine returns to the initial stage of the maintenance mode.
Memo:
Users can change the USB transfer speed with the easier panel operation than the above. The
operating procedure is as follows.
(1) Press the Go and
(2) "PB.USBspeed/ AUTO" appears on the LCD. Press the
required function. Then, press the OK or Go button.
The machine returns to the ready status after a few seconds.
(3) Turn the power switch of the machine off and turn it on again.
CAUTION:
When a user sets the USB transfer speed by either of both operations described above,
indicate the user to turn the power switch of the machine OFF and ON after the machine
returns to the ready status so that the setting is enabled.
Speed)
depended on.
or button to display "MAINTENANCE 45" on the LCD in the initial stage of
buttons at the same time while the machine is in the ready status.
or
5-15
or button
button to select the
Confidential