Replacing the cap
The AccuPoint cap is an expendable item that should be replaced after
prolonged use. The spare AccuPoint cap is supplied with the computer.
1. To remove the AccuPoint cap, firmly pinch the cap and pull it straight
up.
2. Position a new cap on the peg and press it into place.
The peg is square, so be careful to align the cap's square hole with the
peg.
Using the Fingerprint Sensor
This product has a fingerprint utility installed for the purpose of enrolling
and recognizing fingerprints. By enrolling the ID and password to the
fingerprint authentication device, it is no longer necessary to input the
password from the keyboard. Just by swiping the finger against the
fingerprint sensor, the following functions will be enabled:
■
Logon to Windows and access a security-enabled homepage through
IE (Internet Explorer).
■
Files and folders can be encrypted/decrypted and third party access to
them prevented.
■
Disable the password-protected screen-saver when returning from
power-saving (standby) mode.
To "swipe" refers to the action of reading a fingerprint using the fingerprint
sensor.
User's Manual
Figure 4-2 Removing the AccuPoint cap
Operating Basics
4-3