General Information - Jøtul GF 400 DV Sebago Installation And Operation Instructions Manual

General Information

THIS HEATER MUST BE INSTALLED AND MAINTAINED

BY A QUALIFIED SERVICE AGENCY.
The installation and repair of this appliance must be

done by a qualified service person. Failure to properly
install and maintain this heater could result in an
unsafe or hazardous installation, which may result in
a fire, explosion, property damage, personal injury or
loss of life.
This appliance should be inspected before use and

at least annually. More frequent cleaning may be
required due to excessive lint from carpeting, bedding
material, etc. It is imperative that control compart-
ments, burners, and circulating air passageways of
the appliance be kept clean.
THIS APPLIANCE MUST NOT BE CONNECTED TO A

CHIMNEY OR FLUE SERVING ANY OTHER APPLIANCE.
The installation must conform to local codes. Your lo-

cal Jøtul dealer can assist you in determining what is
required in your area for a safe and legal installation.
Some areas require a permit to install a gas burning
appliance. Always consult your local building inspec-
tor, or authority having jurisdiction, to determine
what regulations apply in your area.
CODE COMPLIANCE : Your local officials have final

authority in determining if a proposed installation is
acceptable. Any requirement that is requested by the
local authority having jurisdiction, that is not specifi-
cally addressed in this manual, defaults to local code.
In the absence of local codes, the installation require-
ments must comply with the current National codes.
In the U.S., these requirements are established in the
National Fuel Code, ANSI Z223.1.(NFPA 54). In Canada,
the codes have been established in CAN/CGA B149
Fuel Installation Code.
Installer l'appareil selon les codes ou reglements

locaux, ou, en l'absence de tels reglements, selon les
Codes d'installation CAN/CGA-B149.
DO NOT OPERATE THIS STOVE IF ANY PART HAS BEEN

UNDER WATER. Call a qualified service technician to
inspect the heater and to replace any part of the con-
trol system and any gas control which may have been
under water.
Ne pas se servir de cet appareil s'il a ete' plonge dans

l'eau, completement ou en partie. Appeler un tech-
nicien qualifie pour inspecter l'appareil et remplacer
toute partie du syste'me de controle et toute com-
mande qui ont ete plonges dans l'eau.
Glass Panel
Do not operate this appliance with the glass
front removed, cracked, or broken. Replacement
of the glass should be done by a licensed or
qualified service person. Only remove glass for
routine service. Always handle glass carefully.
Unpacking your stove
1. Remove the Top Plate of the stove by simply lifting it
straight off of the stove body.
2. To open the firebox, disengage the two Glass Frame
Latches located on top of the firebox. Pull each handle
forward to clear the latch from the notch in the frame.
3. Familiarize yourself with the installation requirements
specified in this manual, before beginning the installa-
tion.
Hardware Bag Contents
• Fuel Conversion Kit - LP .................................... 155351
• Ember Bag , 4 oz. ............................................... 129123
THIS FIREPLACE IS SHIPPED FROM THE FACTORY
FOR USE WITH NATURAL GAS ONLY. IF USE WITH
PROPANE IS DESIRED, THE APPLIANCE MUST FIRST
BE CONVERTED USING THE FUEL CONVERSION
KIT PROVIDED, #155351. CONVERSION SHOULD BE
MADE BEFORE THE APPLIANCE IS INSTALLED. SEE
PG. 16.
137750_Rev_L 7.29.10
Glass Frame
Latch
5