Toshiba B-SP2D SERIES Owner's Manual page 33

7. CONNECTING THE SERIAL INTERFACE CABLE
4) Secure the serial interface cable to the printer with the enclosed cable
clamp and SMW-3x8 screw as shown in the picture below.
NOTE: Allow the cable between the connector and the cable clamp to
slack. Failure to do this may damage the internal wire or
connector terminal.
5) Put the enclosed ferrite core on the serial interface cable between the
connector and the cable clamp.
SMW-3x8 Screw
Cable Clamp
NOTE: Use the serial interface cable model CABLE-SP2D-S or
equivalent which meets the following specifications:
- 1.2 m long
- Shield type
- When in use, the enclosed ferrite core is attached.
- Printer side connector is 8-pin Male MINI DIN type.
Section 7.p65
7. CONNECTING THE SERIAL INTERFACE CABLE
Ferrite Core
Serial Interface Cable
7- 2
2
EO1-33052
10/31/2005, 11:41 AM