Toshiba B-SP2D SERIES Owner's Manual page 24

4. INSTALLING THE PRINTER
2) Load a fully charged battery into the printer with the electrode facing
down.
NOTE: Load the battery in the correct orientation as indicated in the following
picture.
3) Close the battery cover completely.
NOTES:
1. If the battery cover is not completely closed, the battery pack may drop
from the printer while it is carried, causing injury.
2. Be careful not to apply excessive force to the battery cover when it is
opened, as this may break the battery cover.
Battery status indication at the power on time
Fully charged:
Battery near end: Flashes in red for a few seconds, and then lights in
Low battery:
If the status indicator does not light at all, there may be one of the following
problems:
• The battery pack is not loaded.
• The battery is almost dead. (The battery has been excessively
discharged.)
• The printer is faulty.
Section 4.p65
Flashes in red for a few seconds, and then lights in
green.
orange.
Flashes in red for a few seconds, and then lights in red.
4- 2
2
EO1-33052
4.1 LOADING THE BATTERY
Battery
Pack
10/31/2005, 11:38 AM