Pptp Xdsl - Planet WNRT-625G User Manual

If you select "Continuous", the router will always connect to the ISP. If the WAN line
breaks down and links again, the router wills auto-reconnect to the ISP.
If you select "Connect On Demand", the router will auto-connect to the ISP when a
client in LAN want to use the Internet and keep connected until the WAN idle
timeout. The router will close the WAN connection if the time period that no one is
Connection Type
using the Internet exceeds the "Idle Time".
If you select "Manual", the router will connect to ISP only when you click "Connect"
manually from the Web user interface. The WAN connection will not disconnected
due to the idle timeout. If the WAN line breaks down and latter links again, the router
will not auto-connect to the ISP. Default: Continuous.
You can specify an idle time threshold (minutes) for the WAN port. This means if no
packets have been sent (no one using the Internet) during this specified period, the
router will automatically disconnect the connection from your ISP.
Note: This "idle timeout" function may not work due to abnormal activities of some
network application software, computer virus or hacker attacks from the Internet. For
Idle Time
example, some software sends network packets to the Internet in the background,
even when you are not using the Internet. So please turn off your computer when
you are not using it. This function also may not work with some ISP. So please make
sure this function can work properly, especially when your ISP charges you by time
used.
When the configuration finished, click "Apply" to next step or click "Cancel" to previous step. After press
"Apply", you will see a web screen to prompt you the configurations save successfully. Please refer to
section 4.2.7 for the information of this screen.
4.2.5

PPTP xDSL

Select PPTP if your ISP requires the PPTP protocol to connect to the Internet. Your ISP should provide
all the information required in this section.
20