Planet WNRT-625G User Manual page 42

The Data Rate is the rate of data transmission for 802.11b/g clients. The
Data Rate WNRT-625G will use the highest possible selected transmission rate to transmit
the data packets.
Set the wireless data transfer rate to a certain value for 802.11n clients. Since
N Data Rate most of wireless devices will negotiate with each other and pick a proper data
transfer rate automatically. Please refer to "N Data Rate Table" as below.
Set channel width of wireless radio. Do not modify default value if you don't know
Channel Width
what it is, default setting is 'Auto 20/40 MHz'.
Preamble type defines the length of CRC block in the frames during the wireless
Preamble Type communication. "Short Preamble" is suitable for high traffic wireless network.
"Long Preamble" can provide more reliable communication.
If you enable "Broadcast ESSID", every wireless station located within the
coverage of this access point can discover this WNRT-625G easily. If you are
Broadcast ESSID
building a public wireless network, enabling this feature is recommended. In
private network, disabling "Broadcast ESSID" can provide better security.
It is recommended to enable the protection mechanism. This mechanism can
decrease the rate of data collision between 802.11b and 802.11g wireless
CTS Protection
stations. When the protection mode is enabled, the throughput of the AP will be a
little lower due to many of frame traffic should be transmitted.
Users can adjust the WNRT-625G output power to 100%, 90%, 75% 50% 25%
TX Power
and 10%. In default, WNRT-625G will work with 100% output power.
The short of Wi-Fi Multi-Media, it will enhance the data transfer performance of
WMM
multimedia contents when they're being transferred over wireless network.
When you set the important Server in the same IP range topology , key the IP
address in the Watch host space and set the time ( 1~60 minutes ). When there is
WatchDog
large traffic in the topology, you can not login the server during the setting time.
The WNRT-625 will reboot to solve the traffic jam status.
When you enable the function, the WNRT-625 wireless users can not Access
Block Relay
each other.
After configuration complete, please click "Apply" button to save the configuration. Then you will see a
screen to prompt you the settings are saving successfully. You may press "Continue" for configure other
settings or "Apply" to restart WNRT-625G with new configuration. Please refer to section 4.2.7 for more
information about this screen.
42