Table of Contents
Advertisement
Configuration
(DMX)
DMX Starting
Address
DMX Personalities
Intimidator™ Wash Zoom 350 IRC User Manual Rev. 1
To set the product in DMX mode for control with a DMX controller, do the following:
1. Make sure the product is plugged into a power source.
2. Connect the male end of a DMX cable to the DMX out socket of the DMX controller and
the female end of the same cable to the DMX in socket on the product.
3. Set the DMX starting address and personality by following the directions below.
When selecting a starting DMX address, always consider the number of DMX channels
needed for the selected DMX personality. Choosing a starting address that is too high can
restrict access to some of the product's channels.
The Intimidator™ Wash Zoom 350 IRC uses either 14 or 29 channels, depending on the
personality. The highest configurable DMX address in 14-channel mode is 499. The highest
configurable DMX address in 29-channel mode is 484.
For more information about DMX download the CHAUVET® DMX Primer from the
CHAUVET® web site http://www.chauvetlighting.com/download.
To set the DMX starting address, do the following:
1. If the display shows a number from 001–512, go to step 5.
2. Press <MENU> repeatedly until 4 icons show on the display.
3. Use <UP> or <DOWN> to highlight Address.
4. Press <ENTER> and a number from 001–512 will show on the display.
5. Use <UP> or <DOWN> to change the number to the desired DMX starting address.
6. Press <ENTER> to select the DMX starting address.
The Intimidator™ Wash Zoom 350 IRC has 2 DMX personalities: a 14-channel personality
and a 29-channel personality.
To set the DMX personality, do the following:
1. Press <MENU> repeatedly until 4 icons show on the display.
2. Use <UP> or <DOWN> to highlight the Run Mode icon.
3. Press <ENTER> and the Run Mode options will show on the display.
4. Use <UP> or <DOWN> to highlight DMX.
5. Press <ENTER>. A green dot will show on the DMX option line and the characters 14CH
or 29CH will show in green.
6. Use <UP> or <DOWN> to switch between 14CH and 29CH.
7. Press <ENTER> to select the DMX personality shown.
After the DMX starting address and personality have been set, there will be a delay of
30 seconds before the display automatically returns to showing the current DMX
address and the DMX personality.
If the display goes blank after 30 seconds, it is because the Display option is set to
OFF. To set the Display option to ON go to Menu > Setup > Display and change the
value to ON. For more information see the
Display
ON/OFF.
Page 13 of 31
Advertisement
Table of Contents
