Table of Contents
Advertisement
M
L
P
AIN
EVEL
ROGRAMMING
Dimmer Mode
LED
Frequency
Fan Mode
Back Light
Key Lock
Information
Reset Factory
Configuration (DMX)
Use DMX configurations to operate the product with a DMX controller.
DMX Personalities
This setting allows you to choose a particular DMX personality.
1.
Go to the DMX Channel main level.
2.
Select the desired personality (2 Ch, 3 Ch, 4 Ch, or 5 Ch).
•
See the
each personality.
•
Make sure that the starting addresses on the various products do not overlap due
to the new personality setting.
DMX Control
In this mode, each product will respond to a unique starting address from the DMX controller. All products
with the same starting address will respond in unison.
1.
Select a DMX personality as shown in
2.
Set the starting address:
a.
Go to DMX Address main level.
b.
Select the starting address (001–512).
The highest recommended starting address for each DMX mode is as follows:
Page 10 of 17
L
EVELS
Off
Dimmer 1–3
600 Hz
1200 Hz
2000 Hz
4000 Hz
25 KHz
Auto
On
On
10S
20S
30S
On
Off
Fixture Hours
Version
UID
No
Yes
DMX Values
section for the highest starting address you can select for
DMX
DMX PERSONALITY
2
3
4
5
D
ESCRIPTION
Linear dimming
Dimming curves: Dimmer 1 (fast) to Dimmer 3
(slow)
PWM frequency
Fan speed based on product temperature
Fan always at maximum
Display backlight always on
Turns off display backlight after 10 sec of inactivity
Turns off display backlight after 20 sec of inactivity
Turns off display backlight after 30 sec of inactivity
Locks display (password is <UP>, <DOWN>, <UP>,
<DOWN>, <ENTER>)
Shows total product hours
Shows installed software version
Shows product ID
Reset to factory defaults
Personalities.
DMX ADDRESS
511
510
509
508
STRIKE 1 User Manual Rev. 2
O
PERATION
Advertisement
Table of Contents
