Product At A Glance; Safety Notes - Chauvet Intimidator Wash Zoom 350 IRC User Manual

Product at a
Glance

Safety Notes

Intimidator™ Wash Zoom 350 IRC User Manual Rev. 1
Use on Dimmer
Outdoor Use
Sound-Activated
DMX
Master/Slave
These notes include important information about the mounting, use, and maintenance of this
product. Read these notes before using the product.
· Always connect the product to a grounded circuit to avoid the risk of electrocution.
· Make sure the power cord is not crimped or damaged.
· Always disconnect the product from the power source before cleaning it or replacing the
fuse.
· Never disconnect the product from the power source by pulling or tugging on the cord.
· If mounting the product overhead, always secure it using a safety cable.
· Make sure there are no flammable materials close to the product when it is operating.
· Avoid direct eye exposure to the light source while the product is on.
· Do not touch the product's housing when the product is operating because the housing can
be very hot.
· This product is not intended for permanent installation.
· The product is for indoor use only! It is rated at IP20.
· To prevent risk of fire or shock, do not expose the product to rain or moisture.
· Always make sure that the voltage of the power source to which the product is connected is
within the range stated on the sticker or rear panel of the product.
· Never connect the product to a dimmer or rheostat.
· Make sure to replace the fuse with another of the same type and rating.
· Always install the product in a location with adequate ventilation, and leave at least 20 in
(50 cm) between the product and adjacent surfaces.
· Always use the handles to carry this product.
· The maximum ambient temperature (Ta) in which the product can be used is
104 °F (40 °C). Do not operate the product at higher temperatures.
· Be sure that no ventilation slots on the product's housing are blocked.
· Never carry the product by the power cord or any moving part.
· In the event of a serious operating problem, stop using the product immediately.
· Never try to repair the product. Repairs carried out by unskilled people can lead to damage
or malfunction. Contact the nearest authorized technical assistance center.
· Keep this User Manual for future reference. If you sell the product to another user, be sure
to give this manual to the next owner.
x
Auto Programs
x
Auto-ranging Power Supply
P
Replaceable Fuse
P
User-Serviceable
P
P
P
P
x
Page 5 of 31