Table of Contents
Advertisement
Configuration
(DMX)
Starting Address
DMX
Personalities
Effect Wheels
Color Wheel
Rotating Gobo
Wheel
Static Gobo
Wheel
Intimidator Spot 455Z IRC User Manual Rev. 4
Set the product in DMX mode to control with a DMX controller.
1.
Connect the product to a suitable power outlet.
2.
Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket on the product.
When selecting a starting DMX address, always consider the number of DMX channels
the selected DMX mode uses. If you choose a starting address that is too high, you could
restrict the access to some of the product's channels.
The Intimidator Spot 455Z IRC uses up to 16 DMX channels in its 16-channel DMX mode,
which defines the highest configurable address to 497.
If you are not familiar with the DMX protocol, download the DMX Primer from
www.chauvetlighting.com.
To select the starting address, do the following:
1.
Press <MENU>.
2.
Use <UP> or <DOWN> to choose Address.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select the starting address.
5.
Press <ENTER>.
The Intimidator Spot 455Z IRC has two DMX personalities, a 16-channel personality and
a 10-channel personality.
To choose which DMX personality to use, follow the steps below:
1.
Press <MENU>.
2.
Use <UP> or <DOWN> to choose Run Mode.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select DMX.
5.
Press <ENTER>.
6.
Use <UP> or <DOWN> until either 16CH (to choose the 16-channel personality) or
10CH (to choose the 10-channel personality) shows on the display.
7.
Press <ENTER>.
Page 11 of 27
Advertisement
Table of Contents
