Table of Contents
Advertisement
Configuration
(DMX)
Starting Address
DMX
Personalities
Intimidator™ Spot Duo 150 User Manual Rev. 1
Set the product in DMX mode to control with a DMX controller.
1.
Connect the product to a suitable power outlet.
2.
Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket on the product.
When selecting a starting DMX address, always consider the number of DMX channels
the selected DMX mode uses. If you choose a starting address that is too high, you could
restrict the access to some of the product's channels.
The Intimidator™ Spot Duo 150 uses up to 20 DMX channels in its 20-channel DMX
mode, which defines the highest configurable address to 493.
If you are not familiar with the DMX protocol, download the DMX Primer from
www.chauvetlighting.com.
To select the starting address, do the following:
1.
Press <MENU> repeatedly until d001—d512 shows on the display.
2.
Use <UP> or <DOWN> to select the starting address.
3.
Press <ENTER>.
The Intimidator™ Spot Duo 150 has three DMX personalities: a 10-channel personality,
a 17-channel personality, and a 20-channel personality.
To choose a DMX personality, follow the steps below:
1.
Press <MENU> repeatedly until 10CH, 17CH, or 20CH shows on the display.
2.
Use <UP> or <DOWN> to select the personality.
3.
Press <ENTER>.
Page 11 of 27
Advertisement
Table of Contents
