Bosch Maxx 5 Operating And Installation Instructions page 50

Problems
Water not visible in the
drum.
Washing solution is not Washing solution is not
completely drained. completely drained.
Water runs out from
under the appliance. under the appliance.
Foam comes out of the
detergent drawer.
The : symbol is
displayed at the end of displayed at the end of
the programme.
The washing has not
been spun correctly.
Spin result unsatisfactory. Reduced Ironing e button touched for reduced spin speed see page
Spin cycle actuated
several times.
Washing result not
satisfactory.
50
Cause
Not a fault.
The water lies below the visible part of the drum.
Pumped blocked by foreign objects.
Fluff producing laundry was
washed. The water drainage pipe or
drain hose is blocked.
Screw fitting of the inlet hose is
leaking.
Drainage hose is leaking.
Too much detergent or detergent
not suitable for use in washing
machines used.
Large laundry items have become
entangled and are not evenly
distributed in the drum.
For safety reasons, the high speed
final spin cycle was automatically
cancelled.
27.
The Rinse K or Spin B programme selected maximum spin speed:
see page 26.
Not a fault.
Unbalanced load detection system is attempting to compensate the
imbalance by spinning the washing several times.
Soiling is greater than expected or
recommended load has been
exceeded.
Detergent was underdosed.
Remedial action
Clean the pump (refer to page 45).
Clean drainage pipe and/or
drainage hose.
Tighten the screw fitting.
Replace the drain hose.
Mix 1 tablespoon of fabric softener
with ½ litre of water and pour into
chamber II of the detergent dispen
ser.
Reduce detergent dosage for next
wash cycle or use detergent which
is suitable for use in washing
machines.
Do not put only large items in the
drum.
Select suitable programme and
touch the Intensive X button or
reduce load.
Dose detergent according to the
manufacturer's instructions.