Flicker Adjustment; Data Transfer - Panasonic PT-AE8000U Service Manual

1. Adjustment item and a procedure
When the following components in this projector are replaced, adjustments are required. Adjust each item according
to the table below.
Adjustment Items

1. 1. Flicker Adjustment

1. 2. Data Transfer

1. 3. Model Information Setup
1. 4. Serial Number Setup
1. 5. Clog Sensor Calibration
1. 1. Flicker Adjustment
1. 1. 1.Adjustment Procedure
1. Select "FLICKER ADJUST" on "EXT OPTION" menu and press "ENTER" button on the main unit or remote control unit.
2. "DESK setting (blue)" is displayed when entering the adjustment mode.
3. Setting value is increased and decreased with the right-arrow "  " and left-arrow "  " buttons.
- Adjust the setting value to minimize the flicker on the screen.
4. The pattern (adjustment display) is switched with the up-arrow " ▲ " and down-arrow " ▼ " buttons.
- There are 6 patterns of "DESK setting (blue)", "DESK setting (red)", "DESK setting (green)", "CEILING setting (blue)",
"CEILING setting (red)" and "CEILING setting (green)".
5. Press "MENU" button on the main unit or remote control unit.
- When "MENU" button is pressed, the setting value at that time is saved into this projector and the adjustment
mode is canceled.
1. 2. Data Transfer
1. 2. 1. Required equipments
1. PC : Use to transfer the backup data.
2. Communication cable : D-sub 9pin (male/emale RS-232C straight)
3. Software : ［Service ORCA11.exe］Adjustment software is downloaded from the projector service homepage.
1. 2. 2. Preparation
1. Connect the RS-232C termanal of projector
and PC with a RS-232C cable.
1. 2. 3. Backup the Data (It is before A-P.C.Board exchange)
1. Switch the projector to "Standby" mode (POWER indicator is Lighting in red).
2. Start up service software ［Service ORCA11.exe］ with a computer.
3. Select language and click the [ OK ] button.
4. 1) Select the Serial Port of the computer.
2) Select a model number.
(Case of AT6000, select the AE8000.)
3) Click the [ Data ] button.
Replaced parts
OPTICAL BLOCK / A-P.C.Board
A-P.C.Board
A-P.C.Board
A-P.C.Board
A-P.C.Board / M3-P.C.board
Computer
③
ADJ - 2
Save data to a PC before A-P.C.B exchange and
write it into a new A-P.C.B.
After the "1.2.Data Transfer" has been
completed, please adjust it.
RS-232C cable (Streight)
②
①
Remarks
Projector