2. 2. Removal of Top Cover
1. Remove the Top panel.
2. Unscrew the 9 screws on the top side and 1 screw on the rear side.
Top cover
2. 3. Removal of A-P.C.Board
1. Remove the Top Cover according to the section 2.2 "Removal of Top Cover".
2. Unscrew the 7 screws and remove the A-P.C.Board block.
A-P.C.Board block
3. Unscrew the 2 screws and remove the Terminal cover and Shading sheet.
Top panel
XTV3+10GFJ
XYN3+F6FJ
Shading sheet
A-P.C.Board
1) Hold the top cover as shown in the diagram.
2) While pushing the arm in the direction of the arrow
(inside projector), pull out from the groove.
* Attaching the top panel
1) Hold the top cover as shown in the diagram.
2) Align the hinge with the support.
3) while pushing the arm in the direction of the arrow
(inside projector) push it into the groove.
XTBT969FJK
DIS-4
XSB3+8FJK
XSB3+8FJK
Terminal cover