Table of Contents
Advertisement
To write shot marks
To write shot marks in recording
and assemble mode
Under Shot Mark Operation menu
item G04, select the type of mark you
want to write. To write a mark, press
the TRIM+/MARK button while
holding the ENTRY/SHIFT button at
the point where you want to write the
mark. The message "RECORD SHOT
MARK" appears on the LCD monitor
and in the lower part of the submenu
screen while the mark is being written.
To write marks in playback,
stop, and search modes
You can only write Post Marks in
these modes.
To write a mark, press the TRIM+/
MARK button and keep it pressed for
2 seconds or longer. This puts the unit
into shot mark write and delete mode
(the ENTRY/SHIFT button flashes).
At the position where you want to
write the mark, press the TRIM+/
MARK button while holding the
ENTRY/SHIFT button. The message
"RECORD SHOT MARK" appears
on the LCD monitor and in the lower
part of the submenu screen, and the
REC button lights while the mark is
being written.
Note
LTC user bits are used to record shot
marks.
If LTC user bits are used for recording
other data, this data may be affected
by the shot marks.
5-2-3 Creating a Virtual
Shot Mark
During playback or search, press and
hold the ENTRY/SHIFT button, and
press the TRIM+/MARK button while
holding the ENTRY/SHIFT button.
A virtual shot mark is entered, and the
message "V-MARK xxx" appears on
the LCD monitor and in the lower part
of the submenu screen (xxx is the
mark number).
5-2-4 Displaying Shot
Mark List
To display the shot mark list, press
and hold the ENTRY/SHIFT button,
and press the TRIM–/LIST button
while holding the ENTRY/SHIFT
button.
Press the buttons again to cancel the
display.
The figure on next page shows the
contents of the shot marker list.
Shot Mark/Shot Data
5-5
Advertisement
Table of Contents
