Table of Contents
Advertisement
2-4 Setting Reference Video Signals
Reference video signals in editing
When the OUT REF is set to REF, the
signal shown in the table below is
selected, depending on whether setup
menu item 309 is set to AUTO1 or
AUTO2.
Note
Normally select AUTO1 and
synchronize the external reference
video signal with the input video
signal.
Setting of setup menu item 309
Synchronization signal for internal
reference video signal generator
Synchronization signal for servo
reference video signal
When the signal selected in the menu is not being input
The servo reference video signal and
internal reference signal generator
synchronize as follows.
When "Input" is selected for the
sync signal (see note d) of the
table on previous page)
When a video signal is not being
input, synchronize with an external
reference video signal.
2-12
Preparations
Select AUTO2 when the external
reference video signal is not
synchronized with the input video
signal. If you select AUTO1 under
these conditions, noise may enter the
video and audio signals, making
editing difficult.
AUTO1
External reference video
signal
Input video signal
When "Ref" is selected for the
sync signal (see note c) of the
table on previous page)
When an external reference video
signal is not being input, there is no
external synchronization. The servo
reference video signal synchronizes
with the output of the internal
reference video signal generator.
AUTO2
Input video signal
Advertisement
Table of Contents
