Using Ac Power - Sony DNW-A25WS Operation Manual

2-1 Power Preparations

2-1-4 Using AC Power

You can operate the unit from an AC
power source by using the AC-550/
550CE AC Adaptor or AC-DN2B AC
Adaptor. Use the AC-550/550CE to
connect the AC power source to the
DC IN connector, and the AC-DN2B
to connect the AC power source to the
battery connector.
To use the AC-550/550CE
As shown in the figure, connect the
AC-550/550CE to the AC power
source and turn it on.
When you connect AC power, the
power supply automatically switches
to the AC power from a battery pack
mounted on the top panel of the unit.
Note
Noise may occur in video and audio
signals at the moment when the unit
switches from the battery pack to AC
power.
POWER switch: ON
AC-550/550CE
DC IN
DC power cord (supplied with
AC-550/550CE)
2-4
Preparations
AC power
cord
(supplied
with AC-
550/550CE)
To AC
power
DC
OUT
To use the AC-DN2B
Follow the procedure below to mount
the AC-DN2B on the top panel of this
unit, and connect to AC power.
When two DNW-A25WS/A25WSP
units are combined, you can supply
both units with power by fitting a
single AC-DN2B to either unit.
1
Remove the cover of the battery
connector.
2
Insert the V-wedge shoe on the
AC-DN2B in the V-groove on one
unit and slide the AC-DN2B until
the battery charging connector is
connected to the battery
connector.
Battery charging
connector
Battery connector