Impex Marcy Classic MCB 880-MG Owner's Manual page 9

STEP 3 (See Diagram 3)
A.) Attach the 57" Cable (#74) to a Pulley (#57). Attach the Pulley to the top opening on the
Lat Bar Frame (#70). Secure it with a M10 x 2 3/8" Allen Bolt (#48), two Pulley Bushings
(#59), and one M10 Aircraft Nut (#51). Make sure the ball stopper on the Cable is
underneath the opening.
B.) Draw the Cable over the Pulley to the open bracket on the rear of the Lat Bar Frame.
Attach a Pulley and secure it with one M10 x 2" Allen Bolt (#49), one L-shaped Cable
Retainer (#75), two Ø ¾" Washers (#39), and one M10 Aircraft Nut (#51).
C.) Draw the Cable around the Pulley then downward to the bracket on the Sliding Weight
Post (#71). Secure it with one M10 x ¾" Allen Bolt (#32), two Ø ¾" Washers (#39), and
one M10 Aircraft Nut (#51).
D.) Insert a M8 x 2 1/8" Allen Bolt (#50) through the holes on the Lat Bar Frame and secure
it with a M8 Aircraft Nut (#52).
E.) Connect the Lat Bar (#72) to the Cable with two C-clips (#62) and one Chain (#61).
8