Impex Marcy Classic MCB 880-MG Owner's Manual page 12

STEP 6 (See Diagram 6)
A.) Attach the Leg Developer (#5) to the open bracket on the Main Frame (#1). Secure it
with one Axle (#42), two M10 x 5/8" Allen Bolts (#30), and two Ø ¾" Washers (#39).
Do not over tighten the bolts. Make sure the Leg Developer is able to swivel.
B.) Insert the U-shaped Pin (#10) into the tube in front of the Main Frame. Secure it with
one Spring (#29), Ø ½" Washer (#28), and M6 x 5/8" Philips Screw (#41).
C.) Insert three Foam Tubes (#9) halfway through the holes on the Main Frame and Leg
Developer. Push six Foam Rolls (#26) onto the Tubes from both ends. Plug six Foam
Roll End Caps (#21) into the Tubes from both ends.
D.) Attach the Curl Bar Handle Support (#45) to the bracket on the Leg Developer.
Secure it with a L-shaped Pin (#27).
E.) Attach an Olympic Sleeve (#14) onto the weight post on the Leg Developer. Attach a
Spring Clip (#15) to the Sleeve.
11
DIAGRAM 6