Page 1
NOTE: Please read all instructions carefully before using this product Table of Contents ® MARCY CLASSIC Safety Notice Hardware Identifier WEIGHT BENCH Assembly Instruction MCB-379 Parts List Warranty Ordering Parts Model MCB-379 Retain This Manual for Reference 05-26-09 OWNER'S MANUAL ®...
EXPLODED DIAGRAM………………………………………………………………. PARTS LIST....................……. WARRANTY....................…. ORDERING PARTS..................… BEFORE YOU BEGIN Thank you for selecting the MARCY CLASSIC MCB-379 Weight Bench by ® IMPEX INC. For your safety and benefit, read this manual carefully before using the machine. As a manufacturer, we are committed to provide you complete customer satisfaction.
IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a piece of exercise equipment. Be sure to read the entire manual before you assemble or operate your machine. In particular, note the following safety precautions: 1.
Page 4
WARNING LABEL REPLACEMENT The Warning Label shown here has been placed on the Cross Brace. If the label is missing or illegible, please call customer service at 1-800-999-8899 for replacement. Apply the label in location shown.
ASSEMBLY INSTRUCTION Tools Required for Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches NOTE: It is strongly recommended that two or more people assemble this machine to avoid possible injury. STEP 1 (See Diagram 1) A.) Connect the Right & Left Upright Beam (#1 & #2) with a Cross Brace (#4) in the Mid- span.
Page 7
STEP 2 (See Diagram 2) A.) Do not tighten Nuts and Bolts until instructed to do so. B.) Attach the Main Seat Support (#3) to the Cross Brace (#4). Secure them together with two M10 x 2 ½” Carriage Bolts (#30), one 1 ¾” x 4 3/8” Bracket (#12), two Ø ¾” Washers (#38), and two M10 Aircraft Nuts (#39).
Page 8
STEP 3 (See Diagram 3) A.) Attach the Leg Developer (#7) to the open bracket on Front Post (#5). Secure it with one M8 x 2 5/8” Allen Bolt (#31), two Ø 5/8” Washers (#37), and one M8 Aircraft Nut (#40).
Page 9
STEP 4 (See Diagram 4) A.) Attach the Backrest Supports (#10) onto both ends of the pivot on the Main Seat Support (#3). Place the other end rest against the Backrest Adjustment Bar (#9). B.) Place the Backrest Board (#15) onto the Backrest Supports. Secure it with four M6 x 1 ½” Hex Bolts (#34) and four Ø...
Page 10
STEP 5 (See Diagram 5) A.) Insert two Foam Tubes (#11) halfway through the holes on Leg Developer (#7). B.) Push four Foam Rolls (#18) onto the Tubes from both ends. C.) Remove the Arm Curl Handle (#14) when doing Leg Developer exercises. DIAGRAM 5...
PARTS LIST KEY NO. DESCRIPTION QUANTITY Right Upright Beam Left Upright Beam Main Seat Support Cross Brace Front Post Arm Curl Stand Leg Developer Diagonal Support Backrest Adjustment Bar Backrest Support Foam Tube 1 ¾” x 4 3/8” Bracket 2 3/8” x 4 ¾” Bracket Arm Curl Handle Backrest Board Seat Pad...
® IMPEX INC. LIMITED WARRANTY ® IMPEX Inc. ("IMPEX ") warrants this product to be free from defects in workmanship and material, under normal use and service conditions, for a period of two years on the Frame from the date of purchase.