Tornado
6.5
Checking the cables
Find out here how you can check the plug connections on the Tornado electronics.
CAUTION! Cables can pull off!
• Remove the electronic panelling carefully on vehicles with a lighting system so that the cables
are not pulled off the light circuit board. The connectors do not have to be removed.
Pre-requisites:
•
Large, flat screwdriver
Please note
Use the screwdriver carefully in order to avoid scratches on the panelling
•
Move the lifter to the uppermost position.
•
Remove the electronic panelling. In doing so
press the cover out of the rear side panelling
on one side using a large, flat screwdriver.
•
Check all cables for signs of damage and
crushing.
•
Be careful with every connector. It must not
come away from the bush.
•
If a connector is loose, use slight pressure to
press the connector into the bush. It must
lock into place.
•
Check whether the connector is fitted firmly
into the bush. If not, please repeat the
preceding work step.
•
Close the electronic panelling. In doing so,
push the rear side panelling away slightly
using a large, flat screwdriver.
Page 36
Service Manual
As at:19.03.2004