Tornado
6.6
Replacing the remote
Pre-requisites:
•
Crosstip screwdriver
•
Wizard software or hand programming device
Please note
All remotes are supplied with a standard drive programme. This does not enable lighting and
regulating motors to function. If you do not wish to re-adjust all parameters, preferably save the
current drive programme before replacing the remote.
•
Switch off the remote.
•
Pull the bus cable (1) out of the remote.
•
Loosen the thumb screw (2).
•
Pull the remote and the remote holder out of
the guiding device.
•
Unscrew both remote holder screws (1)
using the crosstip screwdriver.
•
Installation of the remote is carried out in
reverse order.
•
Adapt the drive programme using the hand
programming device or Wizard software or
transcribe the copy onto the new remote.
•
Check all vehicle functions.
Page 38
Service Manual
As at:19.03.2004