Declaration Of Conformity - Skil PLANER 1570 Original Instructions Manual

Planer

Hide thumbs Also See for PLANER 1570:

Instructions manual (14 pages)

Manual original (10 pages)

Table of Contents

Available languages

- always select a shallow planing depth and repeat the

planing and adjusting process until the required

depth is reached

• Chip outlet 6

- select desired chip outlet side (left or right) with

switch G

- connect vacuum cleaner with adapter H to selected

chip outlet as illustrated

- one may also connect dust bag J to the selected

chip outlet as illustrated

! do not attempt to remove any obstructions from

the chip outlet while knives are rotating

• Safety support K 7

- protects workpiece from damage when tool is put

aside

- will automatically fold backwards when planing

• Operating the tool

- adjust planing depth

- place tool on workpiece

! ensure that only the front shoe rests on the

workpiece and that the knives do not touch it

- switch on the tool by ﬁ rst pressing knob L 2 (=

safety switch which cannot be locked) and then

pulling trigger M 2

! before the knives reach the workpiece, the tool

should run at full speed

- hold the tool ﬁ rmly with both hands and guide it

forward in a continuous stroke 8

! while working, always hold the tool at the grey-

coloured grip area(s)

- use the tool with its base-plate on the workpiece

- do not tilt the tool in order to avoid unwanted planing

marks

- keep ventilation slots Q 2 uncovered

! before switching off the tool, you should lift it

from the workpiece

- switch off the tool by releasing trigger M

• Planing rabbets 9

- select required planing depth

- select rabbeting depth by using rabbeting depth

adjuster N

- place tool on workpiece

- start planing

- maximum rabbeting width 82 mm

- maximum rabbeting depth 15 mm

• When planing rabbets you will achieve better results by

using rip fence P to adjust rabbeting width 0

APPLICATION ADVICE

• For chamfering edges use the V-grooves in the front

shoe !

- set knob D in "0" position

- select one of the 3 V-grooves

! always test out first on a piece of scrap material

• Vibration level

The vibration emission level stated at the back of this

instruction manual has been measured in accordance

with a standardised test given in EN 60745; it may be

used to compare one tool with another and as a

preliminary assessment of exposure to vibration when

using the tool for the applications mentioned

SKIL_IB1570_BR.indd 8

- using the tool for different applications, or with

different or poorly maintainted accessories, may

signiﬁ cantly increase the exposure level

- the times when the tool is switched off or when it is

running but not actually doing the job, may

signiﬁ cantly reduce the exposure level

! protect yourself against the effects of vibration by

maintaining the tool and its accessories, keeping

your hands warm, and organizing your work

patterns

MAINTENANCE / SERVICE

• Always keep tool and cord clean (especially the

ventilation slots Q 2)

• If the tool should fail despite the care taken in

manufacturing and testing procedures, repair should be

carried out by an after-sales service centre for SKIL

power tools

- send the tool undismantled together with proof of

purchase to your dealer or the nearest SKIL service

station (addresses as well as the service diagram of

the tool are listed on www.skil.com.br)

ENVIRONMENT

• In case of discard of that product don't throw in the

common garbage, conduce it for accredited

technical support Skil that will give the appropriate

destiny, following criteria of no aggression to the

environment, recycling the parts and accomplishing

the effective local legislation !