Heading Alignment - Furuno CSH-8L Installation Manual

3.2

Heading Alignment

1. Turn on the power. Locate a target (buoy, etc.) in the bow direction and display it on the
screen at a close range. The heading alignment is correct if the target in the bow
direction is displayed 12 o'clock on the screen. If it is not, go to step 2.
Buoy
2. Read the skewed degree of the target selected at step 1.
3. Press the [MENU] key.
4. Use the [RANGE] control to choose [MENU MODE].
5. Use the [GAIN] control to choose SYSTEM to show the System menu.
** SYSTEM MENU
[MENU MODE]
DIMMER
DISP SELECT
HEADING ADJ
AUTO RETRACT
6. Rotate the [RANGE] control to select HEADING ADJ.
7. Rotate the [GAIN] control to set value so a target directly ahead in bow direction is
displayed at 12 o'clock.
Locating a target to use for aligning heading
**
: SONAR
: 10
: TEMP
: 0°
: OFF
System menu
When the target on the screen is
skewed to the right, the transducer
heading is skewed to the left.
(RANGE CTRL: U/D, GAIN CTRL: L/R)
SOUNDER MARKS
CURRENT
(OFF, 5-16kt)OFF
3. ADJUSTMENT
SYSTEM
3-3