Samsung CLP-550 Setup Manual page 284

G.10
S
PECIFICATIONS
Envelopes with Double Side Seams
Double side-seams envelopes have vertical seams at both ends
rather than diagonal seams. This style may be more likely to
wrinkle. Be sure the seam extends all the way to the corner of
the envelope as illustrated below.
Correct
Incorrect
Envelopes with Adhesive Strips or Flaps
Envelopes with a peel-off adhesive strip or with more than one
flap that folds over to seal must use adhesives compatible with
the heat and pressure in the printer. The extra flaps and strips
might cause wrinkling, creasing, or even jams and may even
damage the fuser.
Envelope Margins
The following gives typical address margins for a commercial
#10 or DL envelope.
Type of Address
Return address
Delivery address
N
:
OTES
• For the best print quality, position margins no closer than 15mm
(0.6in.) from the edges of the envelope.
• Avoid printing over the area where the envelope's seams meet.
Minimum
15 mm (0.6 in.)
51 mm (2 in.)
Maximum
51 mm (2 in.)
90 mm (3.5 in.)