Circuit Boards - GE Profile PFSS6NKW Technical Service Manual

Note: In the following step, the ground wire
connector utilizes a release/locking tab.
ELECTRICAL TERMINAL
RELEASE/LOCKING TAB
9. Disconnect the heater ground wire from the
door closure support.
10. Peel the door closure heater from the door
closure support.
Ground Wire
11. Using a fl at blade screwdriver, pry and push the
tab that holds the bottom and top hinge caps to
the door closure cover.
Hinge Cap
Door Closure Heater
– 65 –

Circuit Boards

The main control, power supply, and fresh food LED
light boards are installed in a recess located in the
back of the refrigerator. The recess is concealed by
a cover that is attached with 2 tabs at the bottom
(not visible) and 2 Phillips-head screws at the top.
To access the boards, it is necessary to remove the
2 Phillips-head screws then lift the cover from the
back of the refrigerator.
Main Control Board
The main control board is positioned behind 2 tabs
at the bottom and attached to the recess with a
Phillips-head screw and a lock tab at the top. The
board is connected to the refrigerator with 13 wire
harnesses. To remove the board, it is necessary to
disconnect the wire harnesses, remove the Phillips-
head screw, and push up the lock tab.
Lock Tab
Tab Tab
(Continued next page)