GE Profile PFSS6NKW Technical Service Manual page 47

Freezer Evaporator Thermistor
To access the freezer thermistor the freezer
evaporator cover must be removed. (See
.) The housing cover can be
Evaporator Cover
removed to disconnect the wire harness to the
thermistor. (See
Freezer Evaporator
The freezer thermistor is located in a plastic holder
attached to the evaporator.
The thermistor holder and the thermistor wiring
are attached to the evaporator with 3 plastic wire
ties. After the plastic wire ties are removed, the
thermistor can be pulled out of the holder.
Holder
Thermistor
Ice Room Thermistor
The ice room thermistor is inserted in the auger
motor cover. To replace the ice room thermistor the
auger motor assembly must be removed. (See
.)
Motor Assembly
The thermistor is connected to the auger motor
assembly with a wire harness.
Freezer
.)
Auger
Thermistor
– 47 –
Pantry Thermistor
The pantry thermistor is inserted in the damper
cover.
To replace the pantry thermistor:
1. Remove the damper assembly
Assembly.)
2. Peel off the foam that seals the damper cover to
the back wall of the refrigerator.
3. Carefully pull out the damper assembly from the
damper cover.
4. Pull out the pantry thermistor from the damper
cover.
Thermistor
. (See Damper
Foam Seal
(Continued next page)